View Advertiser Index
|
Posted on 11/9/2007
|
Parts For Sale and misc
Wiseco pistons, 350 + 030, uses 6" rods and a 3.625 stroke makes a 370ci motor. $250
7 Diamond forged flat tops 350+040 use with 6" rods $100
5 Wiseco pistons, 6018A3 400+030 uses 6" rods and a 3.750 stroke $75
I have singles,pairs and mutiples of assorted pistons and rods.
Eagle 4340 crank, 3500 stroke, $300
Profiled GM steel crank 10/10 $150
400 block, prebored to 4.180, square decked and line bored with main studs. Has bottom 1" hard blocked. oil passages drilled, coolant passages opened up. With all the machine work done to this block it normally sells for $700. But it has some slight shadows that didnt clean in the cylinders right at the very top. So I will sell it for $300
487 casting heads, cleaned and checked, surfaced, new guides. 2.02 int, 1.6 exh, new springs, retainers and locks, bronz guides, pinned studs,$550
New World product/Motown heads, 205 int, 1.6 exh, 64cc chambers, angle plug, $550 bare or complete $800
882 castings, surfaced, cut for 2.05 int and 1.6 exh. cut for screw in studs and guide plates,bronz guides, mild port work $275
1(new) Edelbrock RPM alumanium head, Part #6061 bare $400
set of 291 casting heads, complete stock ready to bolt on ,been setting on the shelf, $250
New Guide Plates, $10 a set
New 7/16 screw in studs, $15 set
New ARP cam lock bolts, $5 pkg
New JE wrist pins, part #927-2.750-15-51S, 130 grams, $100
New Diamond wrist pins, 927-2.850 tappered ends, 140 grams $75
2 and 4 brl intakes, cleaned and crack checked, checked for straightness, $50
Pete Jackson gear drive $50
583 gears used good shape 28 or 31 spline $225
Sunnen rod hone $400
Misc stuff
Carrier shop furnace, used only 6 months, set up on propane has air conditioning coils, $200 like new
Redi heater uses kerosene $50 like new
turbo 400 trans, good shape $100
(SOLD)tool box with tools for use in pits $100 (SOLD)
Upright deepfreeze good condition $75
4.3 litre V-6 rebuilt engine, long block, less than 500 miles on rebuild, got hit in the back. hydraulic roller cam, asking $700 or best offer.
4.3 litre V-6, rebuilt short block, non roller cam, $500 or if you assemble it $300
Contact Information:
Terry Cohoon
Phone: (712)283-2283
Email: [email protected]
|
|
|
|
