View Advertiser Index
|
Posted on 2/20/2010 1:38:28 PM
|
Bunch of 85 Monte Parts
These parts are from a 1985 Monte Carlo drag car project I gave up on about 5 years ago. They have been stored in the attic of my shop. The parts were installed in mock up but never used.
This stuff is on Craigslist and pictures can be seen there.
Lot 1 � $150
Upper and Lower control arms were media blasted and coated with POR-15. New Energy Suspension Hyper Flex polyurethane bushings, new Moog ball joints, and new rubber travel stops. They have been stored in the attic of my shop and the heat has deteriorated the lower ball joint boots and allowed some of the bushings to work themselves out. They will need to be re-installed. They show no damage and they are still like new.
Lot 2 � $50
New inner and outer tie rods ends with new adjusting sleeves. New idler arm. Center link was media blasted and coated with POR-15.
Lot 3 � $100
10� Rotors with 5 on 4 � bolt pattern. New bearings races, and seals. They have been turned but show a small amount of surface rust.
Calipers were new (refurbished) bought at NAPA. New pads and brake lines.
Lot 4 � $20
Rear upper and lower control arms. These are original equipment. They are straight, but need new bushings.
Lot 5 � $75 ($180 new at Jegs)
Un-used, left-over parts from Energy Suspension Hyperflex kit #3.1811OR. This kit is complete for the rear suspension, stabilizer bar, and trans mount, and all the instruction sheets. It does not include the front end parts which were used on Lot 1.
Contact Information:
Chris Derickson
Email: [email protected]
|
|
|
|
