View Advertiser Index
|
Posted on 2/6/2009 1:36:45 PM
|
New 406 IMCA stock car motor
New 406 IMCA stock car motor
Custom cam good for stock car or mod.
Mahle dome pistons 11cc
14.5 to 1
ported double humps
made in usa lifters
lifter valley tray
lifter valley screens
nice lw polished I beam rods 7/16 capscrew bolts
46# 4340 steel crank internal balance
8qt kevko pan and high volume pick up
edelbrock spec IMCA stock car 2701 intake
internal balance
machine shop assembled
aftermarket balancer Pro Series Sfi, 6.75", 10#s for good harmonic control.
new flexplate
new roller rockers 1.6/1.5, Arp 7/16 studs
Lw fuel pump pushrod
Melling Hv oil pump
Arp oil pump stud
Bored and honed with deck plate
Zero deck block
Block reinforced by filling steam holes and plugging and redrilling water cooling holes.
509 heavy casting two bolt block. Not a lw 400 block.
the only used parts in this motor are the std length pushrods. I have all sizes on hand and use what measures right and they happen to be std which I have a bunch of used ones.
Machined and assembled by "Horsepower by Hatterman".
Broke in cam today with 1.3 roller rockers and dyno oil with comp cams break in additive. Dumped that oil and installed 10\40 walmart oil and another comp cams break in additive and new filter. not a spec of metal from cam brgs or lifters in first break in of 35 minutes with low ratio rockers. Installed new 1.5-1.6 full roller rockers and is now ready to go run at the chassis dyno or race.
$5500 as is will pull out of car in front of you.
$6000 after I chassis dyno it.
$200 dollar 400 block core charge.
$150.00 double hump head core charge.
If you want it chassis dynoed with your carb make a deal before I go and Ill do it with your carb. I also need to test a few carbs of my own while there though.
There is nothing wrong with this motor, I just like building them and my machinest is bored and ready to build me another one.
Contact Information:
Jeff, Mc Clelland,Ia
Phone: (712)310-1183
Email: [email protected]
|
|
|
|
