View Advertiser Index
|
Posted on 11/9/2007
|
Parts and Ford Motor For Sale
1991 Ford Mustang engine, 4 cylinder, ran good, this motor is complete pan to top, distributor,starter, alternator, flywheel everything. $200
PISTONS
400 +030 flat tops, use a 6" rod and a 3.800 stroke crank $200
400 +030 flat tops these use a 5.700 rod and a 3.625 stroke crank. $300
(2) Lunati forged flat top pistons, 400+.030 uses 5.7 rod $35
(3) Ross flat top pistons, 400 +.030 for 5.7 rod $30
(1) Wiseco lite wieght xls 350 +.040 piston, uses 6" rod. $10
Crankshafts
Lunati 4340, 3.502 stroke, 350 mains, large rods journals, std, $375
4340 Forged crank,3.500 stroke $300
350 cast crank, was balanced to a 6" rod and light piston, was used on the street only, never raced. $50
BLOCKS
(SOLD)400 +060 2 bolt mains, line bored, surfaced, $300
350 +060 4 bolt mains, line bored, flat decked, bolt holes cleaned and chased. oil passages drilled and tapped, stroker clearenced. $500
HEADS
(1) 487x head bare, crack checked $75
1 pair newer heads, casting # 10110810 fits 91 and up 350s 65cc chambers, cleaned, crack checked, surfaced, fresh valve job, $300
OTHER PARTS
Cam Buttons, made in our shop, $1.75 each
Balance plates, made in our shop, $9 each
New Federal Mogual (H) Bearings, std 400 mains, $40 several sets
New SBC small rod journal bearings, CB745p, CB745p-20, CB745p-60 $15 set may have other sizes?
New mains for Small journal crank, Michigan brand standard, $10
2 barrell intake, cleaned and crack checked, $25
(1) 9" ford center sections, no gears, just carrier and housing. $20
Seat belts, 1 used set, $10, new set $25.
1986 Chevy pickup 4 speed trans, $175 obo with bell housing
(SOLD) Saginaw 3 speed trans,has no lines on input shaft,, $100
Part Washer, works good just dont need 2 of them. $50
Turbo 400 trans , came out of a pickup, has the yoke on the back. $100 came out of a running truck.
Exhaust manifolds $5 pair.
Header Gaskets, $5pr. D port shaping,
Contact Information:
Terry Cohoon
Phone: (712)479-2682
Email: [email protected]
|
|
|
|
