View Advertiser Index
|
Posted on 11/9/2007
|
Parts And Mod Roller For Sale
Mod chassis for sale, basic roller, good straight car for beginner or b-mod. Never been stubbed, $1500 all the parts I have go with it..
350 block, +030, cast crank 20/20, stock rods, hypertec pistonsn, 4 valve relief. static balanced, reground cam, cloyes chain, cast rings, federal mogual bearings, $400
350 4 bolt block, +060, bored but not yet honed, Line bored,clearenced for stroker crank, all the holes have had tread cleaner run through them.good straight deck surface,all the casting slag has been removed for lifter area, Nice block $300
400 block, 2 bolt block fresh +040 bore, not yet honed, straight line bore, oil passages drilled and tapped $300
412ci pistons, 400 +030, uses 6" rods and a 3.800 stroke crank. pistons are used but excellant shape. $200
World products heads, SR torguers, 67cc, screw in studs,stock diameter 600 lift springs, used but good shape, $400
1 set of 291 casting heads, bone stock, they are rebuilt ready to bolt on $150
882 casting heads, cleaned and crack checked, new guides $125 pr.
Edelbrock Performer intake, good shape, $50
2 barrell intake that is cleaned and crack checked, it has been square surfaced, $25
2 barrell intake cores,$10
Engine seal kits, seals up that motor for storage or transportation, $25
383 balance plates $9 shipped
Guide plates flat type, $8 set
NEW Comp Cams and Crane Cams hardened black oxide retainers these are stock diameter, $20 a set while supplies last.
New pr. of copper head gaskets, .060 thick $50
Pull bar brackets, pan hard bar brakets, disc brake brackets, shock tabs, gussets, J bar brackets, all kinds of tabs and other brackets for sale
I have lots of good new and used parts on hand, call if you need something special.
Contact Information:
Terry Cohoon
Phone: (712)479-2251
Email: [email protected]
|
|
|
|
