View Advertiser Index
|
Posted on 11/9/2007
|
Parts For Sale
Wesico pistons, 400+.030 uses 6" rods $350
New Kieth Black hyperutectic flat top pistons, 358ci uses 6" rods and a 3.480 stroke $225
360ci, 350 4 bolt block bored to .058 needs honed yet, line bored and square decked,oil passages drilled and tapped, water passages cleaned and debured, all the bolt holes have been cleaned and chased through, cam bearing boses are straight as a whistle on this one. $550 or I will hone to fit your pistons with torque plates for $650
SOLD 360ci, 4 bolt splayed cap block, pinned cam bearings, main caps are pinned also, 9.000 deck hiegth, lifter bores are corrected and bushed, all passages have been drilled and debured,$900 firm
400 block, prebored to 4.180, square decked and line bored with main studs. Has bottom 1" hard blocked. oil passages drilled, coolant passages opened up. With all the machine work done to this block it normally sells for $700. But it has some slight shadows that didnt clean in the cylinders. So I will sell it for $300
3.500 stroke 4340 crank. $350
3.800 stroke cast crank, $100
SOLD 3.480 stroke scat crank $100
SOLD 3.480 stroke 4340 scaloped and pendulum
under cut crank, $250 has had 1 rod journal repaired
SOLD 3.550 stroke small journal gm steel crank $250
991 heads, 2.02 int/1.6 exh. , new guides,pinned studs, new springs and locks, $375
Turbo 400 trans, used but good shape, $150
Metal shop cabinets that hang on the wall, $100 each 2 left
Note my new phone number and email address
Contact Information:
Terry Cohoon
Phone: 712-283-2283
Email: [email protected]
|
|
|
|
