View Advertiser Index
|
Posted on 11/23/2012 9:07:10 AM
|
Ati balancer, mahle pistons, more
Used 7 inch sbc Ati Super dampner $100
Used seats with cover. Have many from NEW never raced to used. $65 to $125
NEW Solid axles 31 spline. 31� and 28-30.5 cut to fit. $55 each
NEW gun drilled 31 spline axles. 29.5� and 31�. $ 90 each
USED 31 spline axle 28.5 $50
New Connecting rod separator tool. Speedway # 586-66773 $60 ( was $109)
New hydraulic thow out brg set up tool. $25 ( was $49)speedway # 913-81090
NEW ARP pro series 7\16 rockers. 332-7202 part number. $60 shipped
Used titan cordless impact gun with charger and 2 batteries $150
Comp cams ultra pro magnum full roller rockers, 1.52 ratio, 7/16 studs. Chassis dyno time only. $275 shipped. These are part number comp cams 1608-16.
Gooseneck hitch extender\cushioned ride. This goes on your trailer and moves it back to give you more room between the cab and trailer as well as cushion the trailer to truck with the rubber isolaters. $450
New Howards stock diameter valve springs. Electro polished. Howards #98215 with ten degree comp lw machined retainers. Good for .600 lift 7500 rpm. $125
New Mahle flat top pistons 4.165 bore, 1.00 pin height. NEW with pins $400 will make a 436,377,358 depending on stroke and rod length you use in a 400 block.
NEW Gm 19� 4 blade fan $80
Custom cam with solid lifters. NEW. $275 cam and lifters. Custom ground stock car cam for 500cfm motor, very very broad smooth power band. I bought 3 at once and am not building that many motors.
750 4 barrel Jdr slick track carb, has billet vac pod for adj secondarys. Ran one night only. $400
14 inch alum air cleaner base with sure seal o ring. $10 each have two both offset style not centered.
14 inch alum steering wheel missing a few of the nubs off the back side. $25
4.75 bolt pattern Used Floater hubs complete with brgs, rotors and lug nuts. Used Ace\winters\prc brand. $200 pair
New 5 on 5 winters\prc hubs, complete with brgs, lug nuts, seals etc. NEW. $300 pair
60 inch centered floater housing. This has center less ground tubes for bolt on floating mounts etc�NEW $350
13 inch 180 lb afco rear spring. $25
5.5x9.5 springs 1100 $10 each
New 15% reduction krc serpentine lower pulley R Lock. $20 shipped.
Used serpentine krc pulleys 3.5 lower and uppers. 1-1, 2 uppers, 3 lowers. R lock $10 each
Used Krc lower pulley and hub piece that mounts to the balancer. Serpentine. 3.5 not r lock older 2 pin style. $20 both pieces.
Steering wheel quick release and part you weld to shaft. Button style. $10
9� bilst shocks $75 1030lr bite, 2080lr bite, 3080lr bite
Contact Information:
Jeff, Mc Clelland,Ia
Phone: (712)310-1183
Email: [email protected]
|
|
|
|
