View Advertiser Index
|
Posted on 9/12/2012 10:25:37 AM
|
IMCA hoosiers, 434 parts, cnc heads, bilst, more
Used IMCA hoosier tires. Off stock car, not burned up, not hot, only ran one direction one night maybe two. Measure 6.5 32nds at least 8 32nds is new. $40-70 each
750 4 barrel Jdr slick track carb, has billet vac pod for adj secondarys. Ran one night only. $550
Jdr 4412 carb. USRA legal for stock car. Has 1 3\4 base and bore has been milled out some as well as venturis drilled and stepped. Has choke horn still. $550 NEVER raced.
14 inch alum air cleaner base with sure seal o ring. $10 each have two both offset style not centered.
14 inch alum steering wheel missing a few of the nubs off the back side. $25
4.75 bolt pattern Used Floater hubs complete with brgs, rotors and lug nuts. Used Ace\winters\prc brand. $200 pair
New 5 on 5 winters\prc hubs, complete with brgs, lug nuts, seals etc. NEW. $300 pair
60 inch centered floater housing. This has center less ground tubes for bolt on floating mounts etc�NEW $350
Axles all 31 spline. 28.5 solid, 29.5 gun drilled $75 each
13 inch 180 lb afco rear spring. $25
5.5x9.5 springs 975/1100 $10 each
New 15% reduction krc serpentine lower pulley R Lock. $20 shipped.
Used serpentine krc pulleys 3.5 lower and uppers. 1-1, 2 uppers, 3 lowers. R lock $10 each
Used Krc lower pulley and hub piece that mounts to the balancer. Serpentine. 3.5 not r lock older 2 pin style. $20 both pieces.
Cleaned and checked double hump head cores, bare. $25 each
Steering wheel quick release and part you weld to shaft. Button style. $10
9� bilst shocks $75 1030lr bite, 2080lr bite, 3080lr bite
NEW, Angle plug RHS cast iron heads, CnC ported by Hvh and assembled by Jim Wyman, 216cc\61cc. Some hand port work in chambers around plugs. fereah hollow valves, 2.02/1.6. Isky tool room springs, ten degree locks, lw steel retainers, screw in pro series 7/16 studs. $2000 complete dyno time only. For sale due to rules changes.
Crower ultra light 41# gun drilled mains and rods and seriously profiled throws! 434 crankshaft. Used. .010 400 mains, 2� st rods. Big block snout. Also have low nights Ati Balancer for this. Both $1000
Mahle flat top 434 pistons. 4.165 bore 1.00 pin height for 434,406 or 377 depending on rod length. NEW pistons with -5cc valve reliefs. New pins and locks included. $425
Contact Information:
Jeff, Mc Clelland,Ia
Phone: (712)310-1183
Email: [email protected]
|
|
|
|
