View Advertiser Index
|
Posted on 4/26/2011 8:31:59 AM
|
parts for sale
Go here for pics of for sale items..
http://s642.photobucket.com/albums/uu150/jnjfab/parts%20for%20sale/
Metric suspension parts lower a arms $40 ea, spindles $45 ea, rear trail arms $20 ea, All good take off parts.
27.5 alum radiator 3 nights old $90
7/16 ARP studs $20 2 nights
sbc flat guide plates $10 a set
msd blaster coil 3 nights old. $15 ea have 2 with firewall mounts
4.71 3rd member, lw spool, lw ring gear, 31 spline. $250
5.67 3rd member lw spool, lw ring gear. 31sp $500
5.00 3rd member lw spool, lw ring gear, 31sp $500
roller tip rockers,1.5, 7/16 stud with tungsten balls for reduced heat! $70.00 complete set. 2 nights.
Roller rockers, red. 1.6 ratio 7/16 stud with locks, 1 night. $70
Roller tip rockers 7/16 stud, tungsten balls. 1 nights. 1.5-1.6 ratio. $70
Steering shaft joint fits 605 box or small spline 800 box. 3 nights old has a foot of shaft welded to it. $20
22 gallon fuel cell. Jaz with steel cap and flapper installed. $100
New vortec cork and rubber valve cover gaskets. Awesome to glue to covers. $5 set
Sbc 350 head gaskets. Mr gasket black good for hobby, sportmod, stock builds. $5 a set
NEW never ran 400 harmonic balancer shelf worn only $10
400 oem crank $20
External balance plate for rear of crank for 400 or 383. $5 each have 3
NEW bilstien shocks 6010, 4010 9� $85ea
Alum 2 lever shifter, gold in color. $15.00
ATTENTION Custom manual transmission. Run either high or low!!! 10 spline input. T 10 manual trans. In oem Richmond case. Built by Richmond custom for me�. 2 speed straight cut gears, lw rotating assembly, dog rings for shifting on the fly with no clutch, 1.03 and 1.00 gear. Gives you 2 gears at the track all the time to choose from!!! $900 with 2 long slip yokes. If you have 5.29 in the rear end low is 5.43 so you always have two gears to race in. You can shift any time you breath the gas, no clutch needed or issues. This is what Jet runs in his A mod and so do quite a few others. GREAT FOR CHIP RULE!! $900. This is CUSTOM built to this ratio�
NEW 20� 150# Hyper-coil spring. $50 (80 from speedway)
Front springs. 950,1100,1150,1200 5.5x9.5 springs. Just rated. $20 each
Lw Ultra shield seat, 16� $150.00
Longacre accutech, 2 gauge panel, 2 5/8 water and oil, with lights and senders. $65.00
Edelbrock vortec intake #2716 dual plane IMCA approved. $100.00
400 4 bolt block, cleaned and crack checked already� std bore. $300 FIRM
400 2 bolt, not cleaned or checked. Was a runner I was told when I bought it. $200
406 Complete motor. All new parts build was raced 6 nights and broke cam. FRESH new rings, pump, cam, lifters, brgs, valve job, etc. 15.2-1, ported double hump heads, manley race flo stainless valves, performance valve job, 7/16 studs, roller rockers, Custom solid lift cam and lifters that are brand new.. motor was ran 6 nights, got hot 240 then freshened and cam changed. Made 401 hp with a 350 IMCA legal carb. 46lb 4340 steel crank, lw I beam rods with 7/16 cap screws, mahle 11cc dome pistons, kevco pan, Deck reinforced, lifter galley screened, lifter tray installed, Edelbrock IMCA intake. All work and assembly done by Hatterman. $4500.00 obo
434 CRANK>> NEW Ohio 4340 47lb 434 crank. 4.00 stroke, 400 mains. Brand New. $650.00 (No longer available from Ohio!!) 50lb only from Ohio now. Finished in the USA!!!!
NEW MAHLE flat top 436 pistons. For 4.165 bore, 4 inch stroke.1.0 ch. Can use for 377,406 also. NEW with pins locks $450.00
NEW MAHLE flat top 436 pistons. For 4.165 bore, 4 inch stroke. 1.0 ch. Can use for 377,406. NEW with pins locks and rings. $550.00
New 9� 3rd members $425 shipped to you in a storage tote. Mini spool up to 650 ratio. Add 75 for full lw spool, Add 100 for lw ring gear. Any yoke, any spline. Usually ships next day. Assembled with solid pinion spacer and shims, not crush collar. NEW NEW NEW NEW
Brake bias gauges, mini gauges liquid filled in panel. $40.00
461 double hump heads, 2 nights since freshened with good perf valve job. Screw in studs, plates, big springs, stainless valves. READY to bolt on and go today. No porting. All good parts. $300
New Gun drilled Axle. 31 spline. 29.5 long. $65.00 NEW
NEW Pro/Race pro series race balancer, chrome, degree. SFI 18.1. NEW in package. ($229.99 from JR) Sell $100.00
Keith black .100 dome 383 pistons. 4.030 bore, on nice polished x rods, 4-6 nights old, childs albert moly rings. Nice package to put in your block. Balanced and with balance card. $250 all. This is rods, pistons and rings and balance card!!! Not a whole motor..
Quadra jet intake manifold. Modified plenum area thru 4- 3� holes gain of over 15 hp from weind 7547 proven on back to back dyno run by myself, no smoke and mirrors. $200 each. Pics on www.jnjfab.com in the for sale section.
Gm q jet intake manifolds. Un touched. #250 this is the cleanest oem casting available. Best flowing. $95 each
IMCA sport compact. NEW Race ready car. See at www.jnjfab.com 93 grand am gt h.o 180 hp, manual trans, new head, new time chain, new struts. $3000
EMAIL Jeff [email protected]
Contact Information:
Jeff, Mc Clelland,Ia
Phone: (712)310-1183
Email: [email protected]
|
|
|
|
