View Advertiser Index
|
Posted on 1/14/2011 5:35:53 PM
|
Ill be at sioux swap if you want anything brought.
Used alum radiator 10 nights 28 inch. $75.00
Used alum radiator 3 nights $100.00
406 Complete motor. FRESH ALL parts only 6 nights old.�15.2-1, ported double hump heads, manley race flo stainless valves, performance valve job, 7/16 studs, roller rockers, Custom solid lift cam and lifters that are brand new.. motor was ran 6 nights, got hot 240 then freshened and cam changed. Made 401 hp with a 350 IMCA legal carb. 46lb 4340 steel crank, lw I beam rods with 7/16 cap screws, mahle 11cc dome pistons, kevco pan, Deck reinforced, lifter galley screened, lifter tray installed, edelbrock IMCA intake. All work and assembly done by Hatterman. $4500.00 obo
NEW Ohio 4340 47lb 434 crank. 4.00 stroke, 400 mains. Brand New. $650.00
NEW MAHLE flat top 436 pistons. For 4.165 bore, 4 inch stroke. NEW with pins locks $450.00
NEW MAHLE flat top 436 pistons. For 4.165 bore, 4 inch stroke. NEW with pins locks and rings. $550.00
USED Block mounted ps pump with attached plastic reservoir, serpentine pulley. $95.00
New 9� 3rd members $425 shipped to you in a storage tote. Mini spool up to 650 ratio. Add 75 for full lw spool, Add 100 for lw ring gear. Any yoke, any spline. Usually ships next day. Assembled with solid pinion spacer and shims, not crush collar. NEW NEW NEW NEW
4.71 3rd member, lw spool, lw ring gear, 31 spline. $250
Scatter shield lightened to about 16# IMCA legal $125
ATTENTION Custom manual transmission. Run either high or low!!! 10 spline input. T 10 manual trans. In oem Richmond case. 2 speed straight cut gears, lw rotating assembly, shift on the fly with no clutch, 1.03 and 1.00 gear. Gives you 2 gears at the track all the time to choose from!!! $1200 with slip yoke you need to put on your driveshaft as it uses a large one! If you have 5.29 in the rear end low is 5.43 so you always have two gears to race in. you can shift any time you breath the gas, no clutch needed or issues.
RHS vortec heads. Performance valve job. Ten degree locks, fereah valve, 5 nights. Bolt on and go!! $600
Aftermarket Patriot Performance Vortecs, manley race flow valves, milled to 59cc 10 degree locks springs, 17 nights, then 2 nights on complete rebuild. Bolt these on and go!! $600
461 double hump heads, 2 nights since freshened with good perf valve job. Screw in studs, plates, big springs, stainless valves. READY to bolt on and go today. No porting. All good parts. $400
New Gun drilled Axle. 31 spline. 29.5 long. $65.00 NEW
400 4 bolt block, standard bore $400
NEW Pro/Race pro series race balancers. SFI 18.1. NEW in package. ($229.99 from JR) Sell $100.00
��� Link to balancer info�� http://www.pro-race.com/prorace.htm
Keith black .100 dome 383 pistons. 4.030 bore, on nice polished x rods, 4-6 nights old, childs albert moly rings. Nice package to put in your block. Balanced and with balance card. $250 all.
Quadra jet intake manifold. Modified plenum area thru 4 3� holes gain of over 15 hp from weind 7547 proven on back to back dyno run by myself, no smoke and mirrors. $200 each. Pics on www.jnjfab.com in the for sale section.
IMCA sport compact. NEW Race ready car. See at www.jnjfab.com 93 grand am gt h.o 180 hp, manual trans, new head, new time chain, new struts. $3000
16� Afco rear springs, 5 inch. 120, 125, 150, 175. All just rated. $25.00 each
New MSD 6AL in box. $210.00
Kirkey bolt on shoulder supports. PAIR $25
Box of HEI distributors. Included 5-7 dist, at least two mds modules, coils, lots of good parts. $75.00
4 - 17� 2008 dodge dually steel wheels. $75 each. Dealer gets 280 each
17� Butler race seat. Rolled edge construction nice piece. $150
EMAIL JEFF
[email protected]
Contact Information:
Jeff, Mc Clelland,Ia
Phone: (712)310-1183
Email: [email protected]
|
|
|
|
